| 玻璃钢电缆标志桩应设置在明亮的环境中 |
| 添加时间：2019/10/9 15:16:15 浏览次数： |
| 多个玻璃钢电缆标志桩一起设置时，应按禁止、指令、提示类型的顺序先左后右、先上后下排列。 When multiple FRP cable marking piles are set together, they should be arranged in the order of prohibition, instruction and prompt type, left-to-right, top-to-bottom. 玻璃钢电缆标志桩的固定方式分为附着式、悬挂式和柱式三类。悬挂式和附着式的固定应稳固不倾斜，柱式的标志牌和支架应牢固地连接在一起。临时悬拄的标志牌应采取防止脱落措施，室外悬挂的临时标志牌应防止被风吹翻，并宜做成双面的标志牌。 The fixing methods of FRP cable marking piles are divided into three types: attachment type, suspension type and column type. Suspension type and attachment type should be fixed firmly and not inclined, and column type signs and brackets should be firmly connected together. Temporary hanging signs should take measures to prevent falling off. Temporary signs hanging outdoors should be prevented from being blown over by the wind, and should be made into double-sided signs. 玻璃钢电缆标志桩应设置在明亮的环境中，设置高度应尽量与人眼的视线高度相一致；悬挂式和柱式的环境信息标志牌的下缘距地面的高度不宜小于2m；局部信息标志的设置高度应视具体情况决定。标志牌的平面与视线夹角应接近90°，观察者位于z大观察距离时，z小夹角不低于75°。 Fiberglass reinforced plastic cable marking piles should be set in a bright environment, and the height of the marking piles should be consistent with the eye's line of sight as far as possible; the height of the lower edge of the hanging and pillar environmental information marking plates should not be less than 2 m from the ground; and the height of the local information marking should be determined according to the specific circumstances. The angle between the plane of the sign and the line of sight should be close to 90 degrees. When the observer is located at a large observation distance of z, the angle between Z and small is not less than 75 degrees. |
| 上一页 标志桩厂家的防腐是怎样的 |
| 下一页 电缆通道的路径标志 |
Copyright © 技术支持：遨游网络